Configuring By Means Of Gsd File - Siemens ET 200pro Operating Instructions Manual

Small, extremely rugged and high-performance i/o system with ip65/66/67 degree of protection

Hide thumbs Also See for ET 200pro:

Table of Contents

5.2 PROFINET IO

Configuring by Means of GSD File

Introduction

The GSD file allows you to configure ET 200pro in STEP 7 V5.3 SP 2 or higher. For this

purpose, the GSD file must be installed in the configuration software beforehand.

Requirements

You require a GSD file, available for download from the Internet at:

GSD file (http://support.automation.siemens.com)

IM 154-4 PN High Feature interface module:

GSDML-V2.2-siemens-et200pro-"date in yyyymmdd format".xml

Configuring ET 200pro on PROFINET IO in STEP 7

1. Start STEP 7, then select Options > Install New GSD File in HW Config.

2. Select the GSDML file to install from the next dialog box, then confirm with OK. Result:

ET 200pro appears in the PROFINET IO folder of the hardware catalog.

3. The further procedure is the same as in Configuring in STEP 7 (Page 147).

Table of Contents