Wiring The Electronic Module Using The Connection Module; Introduction - Siemens ET 200pro Operating Instructions Manual

4.11

Wiring the Electronic Module using the Connection Module

4.11.1

Introduction

Introduction
You can connect the actuators and sensors to the electronic modules using the following
types of connection module.
● CM IO 4 x M12, CM IO 4 x M12P, CM IO 4 x M12 Inverse, CM IO 8 x M12,
● CM IO 8 x M8 connection module by means of 3-pin M8 circular socket connectors
● Connection module CM IO 2 x M12 by means of 8-pin M12 circular socket connectors for
● CM IO 1 x M23 connection module by means of an M23 circular socket connector for
If you want to configure the cables yourself you will require a suitable circular connector and
cable. The order numbers can be found in the Appendix (Page 462).
Figure 4-17 Sockets and LEDs of the connection modules
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
CM IO 8 x M12P or CM IO 8 x M12D connection module by means of 5-pin M12 circular
socket connectors (X1 to X4 or X1 to X8)
(X1 to X8)
2 actuator/sensor distributors (X1 and X2)
one actuator/sensor distributor (X1)
4.11 Wiring the Electronic Module using the Connection Module
Connection
107