Example Of A Configuration - Siemens ET 200pro Operating Instructions Manual

Configuring
5.1 PROFIBUS DP
5.1.3.4

Example of a configuration

Introduction
The example below explains how to configure an ET 200pro configuration using the GSD
file, and how to group digital output modules in a single byte.
ET 200pro configuration
The diagram below shows a practical example of an ET 200pro configuration using slots
2 to 7:
Figure 5-2
Configuration table and address range
The user is free to select the byte addresses of the inputs and outputs, if the configuration
software supports this. The bit addresses result automatically from the sequence of the
grouped modules.
The table below shows which modules have been grouped and the corresponding address
range.
Slot
146
Example: Configuring an ET 200pro configuration
Module
2 6ES7142-4BD00-0AA0
4DO DC24V
3 6ES7142-4BD00-0AA0*
4DO DC24V
4 6ES7142-4BD00-0AA0
4DO DC24V
5 6ES7142-4BD00-0AA0*
4DO DC24V
6 6ES7141-4BF00-0AA0 8DI
7 6ES7144-4GF00-0AB0 4AI I
Grouping I/O address
Inputs
Yes
Yes
No 0.0 to 0.7
No 1.0 to 8.7
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
Outputs
0.0 to 0.3
0.4 to 0.7
1.0 to 1.3
1.4 to 1.7