Cm Im Dp Ecofast Cu Connection Module For Interface Modules - Siemens ET 200pro Operating Instructions Manual

11.1.2

CM IM DP ECOFAST Cu connection module for interface modules

Order number
6ES7194-4AA00-0AA0
Properties
Properties of the CM IM DP ECOFAST Cu connection module:
● Can be plugged in and attached with screws to the interface module
● Connection of the 1L+ and 2L+ supply voltages and PROFIBUS DP using ECOFAST
● You can loop through the power supplies and PROFIBUS DP using an additional
● PROFIBUS DP address 1 to 125 can be set by means of a DIP switch
● Switched terminating resistor for PROFIBUS DP, set by means of DIP switch
● 1 inscription label
Pin assignment
For information on the pin assignment of CM IM DP ECOFAST Cu, refer to the chapter
Interface modules (Page 287).
Block diagram
①
②
③
Figure 11-1
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
11.1 Connection modules for interface modules with PROFIBUS DP
connectors.
ECOFAST socket.
Connections for the ECOFAST connector: encoder/electronic/load voltage supply and
PROFIBUS DP
DIP switch for terminating resistor
DIP switch for setting the PROFIBUS DP address
Block diagram of CM IM DP ECOFAST Cu for interface modules
Connection modules
251