Cm Im Dp M12 Connection Module, 7/8" For Interface Modules - Siemens ET 200pro Operating Instructions Manual

11.1.3

CM IM DP M12 connection module, 7/8" for interface modules

Order number
6ES7194-4AD00-0AA0
Properties
The CM IM DP M12, 7/8" connection module has the following properties:
● Can be plugged in and attached with screws to the interface module
● Connecting the 1L+ and 2L+ power supplies using 7/8" cable connectors
● Connecting PROFIBUS DP using M12 cable connectors
● The supply voltages and PROFIBUS DP can be looped through using additional sockets.
● PROFIBUS DP address 1 to 125 can be set by means of a DIP switch
● Switched terminating resistor for PROFIBUS DP, set by means of DIP switch
● 1 inscription label
Pin assignment
For details on the pin assignment of CM IM DP M12, 7/8", refer to the chapter Interface
modules (Page 287).
Block diagram
①
②
③
④
⑤
⑥
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
11.1 Connection modules for interface modules with PROFIBUS DP
Connection for 7/8" cable connectors (with pin insert):
Feeding of encoder/electronic supply, load voltage supply
Connection for 7/8" cable connectors (with socket insert):
Looping of encoder/electronic supply, load voltage supply
Connection for M12 cable connectors (with pin insert): Feeding of PROFIBUS DP
Connection for M12 cable connector (with socket insert): Looping through of PROFIBUS DP
DIP switch for terminating resistor
DIP switch for setting the PROFIBUS DP address
Connection modules
253