Diagnostics By Means Of Led Display - Siemens Simatic ET 200SP Manual

Product overview
3.2 BusAdapter BA-Send 1xFC
3.2.3

Diagnostics by means of LED display

LED display
The figure below shows the LED display (status and fault display) of the BusAdapter BA-Send
1xFC.
①
Figure 3-4
Meaning of the LED display
The table below explains the meaning of the status and fault display.
DIAG LED
Table 3- 2 Status and fault display DIAG
DIAG LED
There is no connection between the ET-Connection
interface of the BusAdapter BA-Send 1xFC and the
Off
ET 200AL.
The CPU/interface module does not support the BA-
Send 1xFC.
There is a connection between the ET-Connection
interface of the BusAdapter BA-Send 1xFC and the
On
ET 200AL.
There is (at least) one diagnostics alarm of an ET-
Connection device. Group error for all ET-
Flashes
Connection bus nodes.
Set configuration does not match the actual
configuration on the ET-Connection.
16
DIAG (green/red)
LED display
Meaning Remedy
Check whether the bus cable is interrupted.
Run a firmware update.
---
Check the ET-Connection device.
Check the configuration of the ET-Connection to
see whether a module is missing or defective, or
whether a non-configured module is wired.
Equipment Manual, 11/2020, A5E33344611-AD
Mixed configuration