Siemens ET 200pro Operating Instructions Manual page 108

Connection
4.11 Wiring the Electronic Module using the Connection Module
Requirements
Before you start to wire the connection modules of the electronic modules, switch off the
supply voltage or disassemble the connection module.
Note
It is easier to wire the connection module after you removed it from the electronic module.
Required tools
You need a stripping tool and a screwdriver for wiring the M12 connector, if you are
fabricating your own cables.
Accessories required for digital electronic modules
Connection module
CM IO 4 x M12
CM IO 4 x M12P
CM IO 4 x M12 Inverse
CM IO 8 x M12
CM IO 8 x M12P
CM IO 8 x M12D
CM IO 8 x M8
CM IO 2 x M12
CM IO 1 x M23
Accessories required for analog electronic modules
● Preassembled cable with 5-pin M12 connector
● Alternatively: 2-, 3-, 4-, or 5-wire shielded flexible copper cable, conductor cross-section
● Shielded cables
108
≤ 0.75 mm and 5-pin M12 connector, shielded
2
Required accessories
Preassembled cable with 5-pin
M12 connector
Preassembled cable with 3-pin
M8 connector
Actuator/sensor distributor with
assembled cable and 8-pin M12
connector
Actuator/sensor distributor with
assembled cable and 12-pin
M23 connector
Operating Instructions, 03/2013, A5E00335544-08
Alternatively: 2-, 3-, 4-, or 5-wire
flexible copper cable, conductor
cross-section ≤ 0.75 mm
2
5-pin M12 connector
Optional: Shielded cables
Alternatively: 3-wire flexible
copper cable, conductor cross-
section ≤ 0.75 mm and 3-pin
2
M8 connector
Optional: Shielded cables
---
---
ET 200pro distributed I/O system
and