Siemens ET 200pro Operating Instructions Manual page 321

Pin assignment of the load voltage supply at the CM PM PP connection module
View of the push-pull cable connector
* Terminals 1 and 2 are jumpered between X01 IN and X02 OUT in the connection module.
Block diagram
The figure below shows the block diagram of the power module PM-E
①
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
Connections of the 2L+ load voltage supply
Terminal Description
Feed for X01 IN
Forwarding X02 OUT
1 1L+ electronics/encoder supply *
2 Ground for electronics/encoder supply 1M*
3 2L+ load voltage supply
4 Ground for load voltage supply 2M
5 Functional earth
Power modules
13.1 PM-E power module
321