Siemens ET 200pro Operating Instructions Manual page 131

Required accessories
● Cables for feeding and looping through of the 2L+ load voltage supply:
● M20 cable glands (included)
Opening and preparing the connection module
1. Remove the two screws from the bottom of the connection module using a crosstip
2. Remove the cover from the connection module.
3. Install M20 screwed cable glands at the cable inlets using an open-end wrench. The
4. Feed the load voltage supply cables through the cable glands.
Connecting the load voltage supply
1. Strip the wires to a length of 11 mm, then crimp the wire end ferrules.
2. Using a 3-mm screwdriver (tightening torque 0.5 N/m to 0.7 N/m), secure the cables for
Terminating and installing the connection module
1. Insert the cover onto the connection module, while pulling back the cables through the
2. Tighten the two screws on the bottom of the connection module using a crosstip
3. Tighten the cable strain relief of the M20 cable glands with the open-end wrench
4. Insert the connection module into the power module.
5. Screw the connection module into the power module (torque = 1.5 N/m). Tighten both
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
4.12 Connecting the Power Module with the CM PM-E Direct Connection Module
– 2-core flexible Cu cable, conductor cross-section ≤ 2.5 mm
– 4-wire shielded cable, conductor cross-section ≤ 2.5 mm
screwdriver.
blanking plate will break off automatically when you screw in the glands. Tighten the
cable glands on the connection module (torque = 3 N/m).
feeding and looping through at Terminal X01 (load voltage supply 2L+).
➀ Feeding of the 2L+ load voltage supply
➁ Looping through of the 2L+ load voltage supply
glands.
screwdriver.
(torque = 3 N/m).
screws evenly. The screws are already inserted in the connection module.
Connection
2
2
131