Siemens ET 200pro Operating Instructions Manual page 417

Technical specifications
Technical specifications
Dimensions and weight
Dimensions W x H x D (mm)
Weight
Voltages and currents
1L+ electronics/encoder supply
Short-circuit protection
Reverse polarity protection
Current consumption
•
•
Power loss of the module
Analog outputs
Number of analog outputs
Cable length, shielded
No-load voltage
Actuator supplies
Number of actuator supplies
Total current up to 55 °C
Short-circuit protection
•
Actuator selection data
Output ranges (nominal value)
•
Load impedance (in the nominal range of the output)
•
•
Permitted current at current output (destruction
limit)
Wiring the actuators
•
Analog value generation
Conversion principle
Conversion time per channel, in ms
•
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
15.6 Analog electronic module 4 AO I High Feature (6ES7145-4GF00-0AB0)
From backplane bus
From 1L+ electronics/encoder supply (no
encoder connected)
Response threshold
Current
For current outputs
At current outputs with inductive load
At current output with 2-wire connection
Cycle time in ms (see Appendix
times
)
45 x 130 x 35
Approx. 150 g
24 V DC
Yes
Yes; against destruction
10 mA
110 mA
Typ. 2.3 W
4
Max. 30 m
Max. 16 V
4
Max. 1 A
Yes, electronic, for each module, to ground
Min. 1.4 A
±20 mA
4 to 20 mA
0 to 20 mA
Max. 0.6 kΩ
Max. 1 mH
100 mA
Yes
R network
0.7 ms
Number of active channels per module x
Response
conversion time
Analog electronic modules
417