Connecting The Interface Module To The Cm Im Dp M12, 7/8" Connection Module - Siemens ET 200pro Operating Instructions Manual

4.7 Connecting the Interface Module to the CM IM DP M12, 7/8"
Connection Module
Introduction
You connect the power supplies and PROFIBUS DP to the CM IM DP M12, 7/8" connection
module.
DP1 X03
DP2 X04
X01 DC 24V
X02 DC 24V
Requirements
● The interface module (including the bus module) and the connection module are mounted
● You have set the PROFIBUS DP address on the connection module according to your
● The terminating resistor must be activated if no loop cables are connected.
Required tools
Screwdriver and stripping tool for wiring the M12 and 7/8" cable connectors, if you are
fabricating your own cables.
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08

4.7 Connecting the Interface Module to the CM IM DP M12, 7/8" Connection Module

M12 circular socket connector (with male contact insert) for feeding PROFIBUS DP
M12 circular socket connector (with female contact insert) for forwarding
PROFIBUS DP
7/8" circular socket connector (with male contact insert) for feeding the 1L+
electronics/
encoder supply and 2L+ load voltage supply
7/8" circular socket connector (with female contact insert), for looping the 1L+
electronics/
encoder supply and 2L+ load voltage supply
on the rack.
configuration.
Connection
91