Connecting The Im 154-4 Pn High Feature Interface Module With Cm Im Pn Pp Cu - Siemens ET 200pro Operating Instructions Manual

4.9 Connecting the IM 154-4 PN High Feature Interface Module with
CM IM PN PP Cu
Introduction
You connect the power supplies and PROFINET IO to the CM IM PN PP Cu connection
module. The IM 154-4 High Feature interface module is equipped with an internal
PROFINET switch. This allows the direct forwarding of PROFINET or the direct connection
of an additional IO device (e.g., ET 200pro with IM 154-8 CPU).
X03 DC 24V
X04 DC 24V
X02 P1 R
X02 P2 R
PROFINET
Modules with PROFINET interfaces may only be operated in LANs (Local Area Networks)
in which all connected devices are equipped with SELV/PELV power supplies (or have
equivalent protection).
A data transfer terminal (modem, for example) that guarantees this level of safety must be
used for the interface to the WAN (Wide Area Network).
Requirements
The IM 154-4 High Feature interface module (including the bus module) and the
CM IM PN PP Cu connection module have been installed on the rack.
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08

4.9 Connecting the IM 154-4 PN High Feature Interface Module with CM IM PN PP Cu

Push-pull socket (with male connector) for feeding the 1L+ electronics/encoder supply
and the 2L+ load voltage supply
Push-pull socket (with male connector) for looping the 1L+ electronics/encoder supply
and the 2L+ load voltage supply
Push-pull socket for RJ45 for feeding PROFINET IO
Push-pull socket for RJ45 for forwarding PROFINET IO
CAUTION
Connection
99