Profinet Io; Configuring In Step 7 - Siemens ET 200pro Operating Instructions Manual

Small, extremely rugged and high-performance i/o system with ip65/66/67 degree of protection

Hide thumbs Also See for ET 200pro:

Table of Contents

PROFINET IO

Introduction

The ET 200pro is listed in the hardware catalog of HW Config after you start STEP 7.

Requirements

IM 154-4 PN High Feature interface module: 6ES7154-4AB10-0AB0

● STEP 7 V5.4 + SP2 + HSP or higher

● Assignment of a name to the IO device See Section Assigning device names to the

1. Start SIMATIC Manager.

2. Create a new project.

3. Configure ET 200pro in HW Config.

4. Drag-and-drop the modules from the hardware catalog to the configuration table.

5. Double-click the first module of ET 200pro in the configuration table and set its

6. Parameterize all other modules of ET 200pro.

7. Save the configuration, or download it to the IO controller.

For additional information, refer to the STEP 7 Online Help.

Table of Contents