Led Display On The Electronic Interface Module - Siemens ET 200pro Operating Instructions Manual

Alarm, error and system messages
9.3 LED display on the power, electronic and pneumatic interface modules
9.3.4

LED display on the electronic interface module

Introduction
The LED display for the pneumatic interface module is on the right side of the front panel.
LED display for the 16 DO 24 V DC CPV10 and 16 DO DC 24V CPV14 pneumatic interface modules
The figure below shows the position and layout of the LED display of the
16 DO DC 24V CPV10 and 16 DO DC 24V CPV14 pneumatic interface modules.
①
②
Status and error LEDs of the pneumatic interface modules
Table 9- 13
LEDs
SF
On
Off
238
GE: Group error (red LED)
Status display (green LEDs)
Status and error displays of the pneumatic interface modules
Meaning
Status and error
displays
--- Incoming diagnostic message
No parameters or faulty
parameters
On (green LED) Valve 0.0 (OUT0) to 1.7 (OUT15)
enabled
Remedy
Analyze the diagnostic data.
Check the parameter settings.
---
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08