Connecting The Outgoing Module With The Cm Pm-O Pp Connection Module - Siemens ET 200pro Operating Instructions Manual

Connection

4.15 Connecting the Outgoing Module with the CM PM-O PP Connection Module

4.15 Connecting the Outgoing Module with the CM PM-O PP Connection
Module
Introduction
You tap the 1L+ electronic/encoder supply and the 2L+ load voltage supply on the
CM PM-O PP connection module using the push-pull cable connector X01 OUT or X02 OUT.
Requirements
● The outgoing module and connection module are mounted on the rack.
Required tools
Screwdriver and stripping tool for wiring the push-pull cable connector, if you are fabricating
your own cables.
Required accessories
● Prefabricated cable with push-pull cable connector. The cables are available in different
lengths.
● If you are fabricating your own cables: 5-wire cable and push-pull cable connector for
1L+/2L+
136
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08