Removing The Lower Bezel - IBM x3100 M5 Type 5457 Installation And Service Manual

Removing the lower bezel

This procedure applies only to the 5U server model with hot-swap power supplies.
To access the hard disk drives on the 5U server model with hot-swap power
supplies, you must first remove the lower bezel.
1. Read the safety information in "Safety" on page vii and "Installation
2. If you are replacing a non-hot-swap component, turn off the server and all
3. Press the blue-colored release button on the right side of the lower bezel and
Figure 23. Lower bezel removal for 5U server model with hot-swap power supplies
4. If you are instructed to return the lower bezel, follow all packaging
42
System x3100 M5 Type 5457: Installation and Service Guide
guidelines" on page 35.
attached devices; then, disconnect all power cords and external cables.
rotate the lower bezel downward to disengage from the chassis.
instructions, and use any packaging materials for shipping that are supplied to
you.