Table of Contents
Advertisement
2
1
Figure 105. Installing battery holder and bracket into chassis for 5U server model with
hot-swap power supplies
5. Stand the server back up in its vertical position.
6. Install and lock the side cover (see "Replacing the side cover" on page 182).
7. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing and replacing Tier 1 CRUs
This section provides information for removing and replacing Tier 1 CRUs in the
server.
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing and installing internal drives
Use this information to remove and install internal drives.
The following figure shows the locations of the four 3.5" simple-swap hard disk
drive bays in the 4U server model with non-hot-swap power supplies.
201
Chapter 6. Removing and replacing components
Advertisement
Table of Contents
Troubleshooting
