Removing The Operating Temperature Enhancement Kit - IBM x3100 M5 Type 5457 Installation And Service Manual

Removing the operating temperature enhancement kit

Use this information to remove the operating temperature enhancement kit
To remove the operating temperature enhancement kit on the 4U server model
with non-hot-swap power supplies, complete the following steps. For 5U server
models with hot-swap power supplies, please see the next sub-section.
1. Read the safety information in "Safety" on page vii and "Installation
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Remove the bezel (see "Removing the bezel" on page 40).
4. Carefully turn the server on its side so that it is lying flat, with the cover facing
5. Remove the side cover (see "Removing the side cover" on page 38).
6. Disconnect the thermal sensor connector from the system board and open the
Figure 203. Thermal sensor connector removal from system board for 4U server model with
non-hot-swap power supplies
7. Remove the thermal sensor board by pulling apart the securing clips of the
290
System x3100 M5 Type 5457: Installation and Service Guide
guidelines" on page 35.
and external cables.
up.
Attention: Do not allow the server to fall over.
cable clips.
thermal sensor board holder.
Thermal sensor
connector