IBM x3100 M5 Type 5457 Installation And Service Manual page 244

USB embedded
hypervisor flash
device connector
Figure 131. USB hypervisor flash device connector location on system board for 4U server
model with non-hot-swap power supplies
7. Slide the lockbar on the flash device connector to the unlocked position and
USB embedded
hypervisor
flash device
Figure 132. USB hypervisor flash device removal from system board for 4U server model
with non-hot-swap power supplies
8. If you are instructed to return the hypervisor memory key, follow all packaging
To remove the system board on the 5U server model with hot-swap power
supplies, complete the following steps. For 4U server models with non-hot-swap
power supplies, please see the above sub-section.
228
System x3100 M5 Type 5457: Installation and Service Guide
pull the USB flash device out of the connector.
instructions, and use any packaging materials for shipping that are supplied to
you.
Note: You must configure the server not to look for the hypervisor USB drive.
See "Configuring the server" on page 94 for information about disabling
hypervisor support.
Lockbar