Replacing The Bezel - IBM x3100 M5 Type 5457 Installation And Service Manual

Replacing the bezel

This procedure applies only to 4U server models with non-hot-swap power
supplies.
To install the bezel on 4U server models with non-hot-swap power supplies,
complete the following steps.
1. Read the safety information in "Safety" on page vii and "Installation
2. Insert the three tabs on the bezel into the corresponding holes in the front of
3. Rotate the bezel to the server until it locks securely into place.
Figure 87. Bezel installation for 4U server model with non-hot-swap power supplies
4. Reconnect the external cables and power cords; then, turn on the attached
188
System x3100 M5 Type 5457: Installation and Service Guide
guidelines" on page 35.
the server.
devices and turn on the server.