Replacing The Hot-Swap Power Supply Cage - IBM x3100 M5 Type 5457 Installation And Service Manual

Retaining
clips
Figure 213. Hot-swap power supply cage and screw removal for 5U server model with
hot-swap power supplies
9. If you are instructed to return the power-supply cage, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.

Replacing the hot-swap power supply cage

This procedure applies only to the 5U server model with hot-swap power supplies.
To install the hot-swap power supply cage in the 5U server model with hot-swap
power supplies, complete the following steps.
1. Read the safety information in "Safety" on page vii and "Installation
guidelines" on page 35.
2. Place the power-supply cage into the chassis and slide it toward the rear of the
server until the retaining clips engage the top of the chassis, then install the
four screws to secure the power-supply cage to the chassis.
Screws
Chapter 6. Removing and replacing components
297