IBM x3100 M5 Type 5457 Installation And Service Manual page 248

1. Read the safety information in "Safety" on page vii and "Installation
2. Locate the USB embedded hypervisor flash device connector on the system
USB embedded
hypervisor flash
device connector
Figure 137. USB hypervisor flash device connector location on system board for 5U server
model with hot-swap power supplies
3. Align the USB flash device with the connector on the system board and push it
4. Slide the lockbar toward the riser-card assembly to the locked position until it
USB embedded
hypervisor
flash device
Figure 138. USB hypervisor flash device installation for 5U server model with hot-swap power
supplies
5. Rotate the rear adapter-retention bracket to the closed (locked) position.
6. Stand the server back up in its vertical position.
7. Install and lock the side cover (see "Replacing the side cover" on page 182).
232
System x3100 M5 Type 5457: Installation and Service Guide
guidelines" on page 35.
board.
into the connector until it is firmly seated.
is seated firmly.
Lockbar