Table of Contents
Advertisement
1. Read the safety information in "Safety" on page vii and "Installation
2. Turn off the server and peripheral devices and disconnect the power cords and
3. Unlock the side cover; then, press the cover-release latch down (as shown in
Cover-release
latch
Figure 19. Side cover removal for 5U server model with hot-swap power supplies
4. If you are instructed to return the side cover, follow all packaging instructions,
Removing the air baffle
This procedure applies only to 4U server models with non-hot-swap power
supplies.
To remove the air baffle, complete the following steps.
1. Read the safety information in "Safety" on page vii and "Installation
2. Turn off the server and peripheral devices and disconnect the power cords and
3. Unlock and remove the side cover (see "Removing the side cover" on page 38).
4. Carefully turn the server on its side so that it is lying flat, with the system
5. Grasp the top of the air baffle and lift it out of the server.
guidelines" on page 35.
all external cables (see "Turning off the server" on page 26).
the illustration) to remove the cover.
Key lock
Attention: For proper cooling and airflow, replace the server cover before you
turn on the server.
and use any packaging materials for shipping that are supplied to you.
guidelines" on page 35.
all external cables (see "Turning off the server" on page 26).
board facing up.
Attention: Do not allow the server to fall over.
Chapter 2. Installing optional devices
39
Advertisement
Table of Contents
Troubleshooting
