Table of Contents
Advertisement
Microprocessor
bracket frame
Microprocessor
release lever
Figure 223. Microprocessor socket levers and retainer engagement for 4U server model with
non-hot-swap power supplies
7. Install the heat sink:
Attention: Do not touch the thermal material on the bottom of the heat sink.
Touching the thermal material will contaminate it. If the thermal material on
the microprocessor or heat sink becomes contaminated, contact your service
technician.
a. Align the screw holes on the heat sink with the holes on the system board.
b. Tighten the screws with a screwdriver, alternating among the screws until
they are tight. If possible, each screw should be rotated two full rotations
at a time. Repeat until the screws are tight. Do not overtighten the screws
by using excessive force.
Microprocessor
Alignment
marks
System board
Chapter 6. Removing and replacing components
305
Advertisement
Table of Contents
Troubleshooting
