Removing The Battery Holder From 5U Server Model - IBM x3100 M5 Type 5457 Installation And Service Manual

Hide thumbs Also See for x3100 M5 Type 5457:

Table of Contents

Hard disk drive cage

Figure 99. Rotating hard disk drive cage into chassis for 5U server model with hot-swap

power supplies

10. Install and lock the side cover (see "Replacing the side cover" on page 182).

11. Reconnect the external cables and power cords; then, turn on the attached

Removing the battery holder from 5U server model

Use this information to remove the battery holder from 5U server model

To remove the battery holder from the 5U server model with hot-swap power

supplies, complete the following steps.

1. Read the safety information in "Safety" on page vii and "Installation

2. Turn off the server and all attached devices; then, disconnect all power cords

3. Unlock and remove the side cover (see "Removing the side cover" on page 38).

4. Carefully turn the server on its side so that it is lying flat, with the cover facing

5. Remove the battery holder and bracket from the chassis by unscrewing the

System x3100 M5 Type 5457: Installation and Service Guide

Note: You may need to slightly lift up the cage in order to press and hold the

retaining tab.

6. Install the hard disk drive fan duct onto the hard disk drive cage (see

"Replacing the hard disk drive fan duct" on page 225).

7. Stand the server back up in its vertical position.

8. Install the hot-swap hard disk drives that you removed from the hard disk

drive cage (see "Replacing a hot-swap hard disk drive" on page 220).

9. Install the lower bezel (see "Replacing the lower bezel" on page 190).

devices and turn on the server.

guidelines" on page 35.

and external cables.

Attention: Do not allow the server to fall over.