IBM x3100 M5 Type 5457 Installation And Service Manual page 310

Thermal sensor
connector
Figure 208. Thermal sensor board installation for 5U server model with hot-swap power
supplies
3. Connect the thermal sensor connector to the system board. Remember to close
Figure 209. Installing thermal sensor connector to system board for 5U server model with
non-hot-swap power supplies
4. Stand the server back up in its vertical position.
5. Install the upper bezel (see "Replacing the upper bezel" on page 192).
6. Install the lower bezel (see "Replacing the lower bezel" on page 190).
7. Install and lock the side cover (see "Replacing the side cover" on page 182).
8. Reconnect the external cables and power cords; then, turn on the attached
294
System x3100 M5 Type 5457: Installation and Service Guide
holes as shown in the illustration.
Cable clips
the cable clips to secure the cable.
devices and turn on the server.
Thermal sensor