Replacing The Operator Information Panel Assembly - IBM x3100 M5 Type 5457 Installation And Service Manual

10. Press on the release tab of the operator information panel assembly and pull
Operator information
panel assembly
Figure 160. Operator information panel assembly removal for 5U server model with hot-swap
power supplies
11. If you are instructed to return the operator information panel assembly, follow

Replacing the operator information panel assembly

Use this information to replace the operator information panel assembly
To install the operator information panel assembly on 4U server models with
non-hot-swap power supplies, complete the following steps. For the 5U server
model with hot-swap power supplies, please see the next sub-section.
248
System x3100 M5 Type 5457: Installation and Service Guide
8. Remove the hot-swap power supplies and the hot-swap power-supply cage
(see "Removing the hot-swap power supply" on page 263) and "Removing the
hot-swap power supply cage" on page 295).
9. Disconnect the operator information panel assembly cable from the system
board, and note the routing of the cable (see "System-board internal
connectors" on page 30 for the location of the operator information panel
assembly connector).
the assembly toward the rear of the server; then, remove the operator
information panel assembly from the chassis.
Release tab
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
1. Read the safety information in "Safety" on page vii and "Installation
guidelines" on page 35.
2. Reroute the operator information panel assembly cable into the opening.
Note: Carefully pull the cable out from the opening. Do not allow the LED to
disconnect from the operator information panel assembly.
3. Insert the bottom tabs of the operator information panel assembly into the
corresponding holes and rotate the assembly toward the chassis.