Figure 173. Rear adapter-retention bracket removal for 5U server model with hot-swap power
supplies
Replacing the rear adapter retention bracket
This procedure applies only to the 5U server model with hot-swap power supplies.
To install the rear adapter-retention bracket on the 5U server model with hot-swap
power supplies, complete the following steps.
1. Read the safety information in "Safety" on page vii and "Installation
2. Position the rear adapter-retention bracket so that the hole in one of the hinge
3. Rotate the rear adapter-retention bracket into place so that the hole in the
258
System x3100 M5 Type 5457: Installation and Service Guide
free of the hinge pin; then, grasp the bracket on the other side at the hinge
point, pull inward until the bracket is free of the hinge pin, and remove the
rear adapter-retention bracket from the server.
guidelines" on page 35.
points is aligned with the hinge pin on the chassis; then, place the hinge pin
through the hole on the chassis.
opposite hinge point snaps into place over the hinge pin on the chassis.
Rear adapter
retention
bracket
Hinge pin