IBM x3100 M5 Type 5457 Installation And Service Manual page 230

Figure 115. Tape drive installation for 4U server model with non-hot-swap power supplies
10. Route the signal cable so that it does not block the airflow to the rear of the
11. If you have another drive to install or remove, do so now.
12. Install the air baffle (see "Replacing the air baffle" on page 185).
13. Install the side cover (see "Replacing the side cover" on page 182).
14. Stand the server back up in its vertical position.
15. Install the bezel (see "Replacing the bezel" on page 188
16. Reconnect the external cables and power cords; then, turn on the attached
Attention: If no tape drive is installed, it is important to reinstall the filler back to
the bay.
To install a tape drive on the 5U server model with hot-swap power supplies,
complete the following steps. For 4U server models with non-hot-swap power
supplies, please see the above sub-section.
214
System x3100 M5 Type 5457: Installation and Service Guide
Drive retainer clip
8. Carefully turn the server on its side so that it is lying flat, with the cover
facing up.
Attention: Do not allow the server to fall over.
9. Connect one end of the applicable signal cable into the rear of the drive and
make sure that the other end of this cable is connected into the applicable
connector on the system board.
drives or over the microprocessor and dual inline memory modules (DIMMs).
devices and turn on the server.
1. Read the safety information in "Safety" on page vii and "Installation
guidelines" on page 35.
2. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
EMC filler
Tape drive