Figure 84. Air baffle installation for 4U server model with non-hot-swap power supplies
4. Install and lock the side cover (see "Replacing the side cover" on page 182).
5. Reconnect the external cables and power cords; then, turn on the attached
Removing the bezel
This procedure applies only to 4U server models with non-hot-swap power
supplies.
When you work with some devices on 4U server models with non-hot-swap power
supplies, such as the drives in bays 3 through 6, you must first remove the bezel to
access the devices.
1. Read the safety information in "Safety" on page vii and "Installation
2. Press the button on the left edge of the bezel; then, rotate the left side of the
186
System x3100 M5 Type 5457: Installation and Service Guide
devices and turn on the server.
guidelines" on page 35.
bezel away from the server until it disengages and set it aside.
Note: When rotating the bezel to a certain point, it may automatically
disengage from the chassis.
Air baffle