IBM x3100 M5 Type 5457 Installation And Service Manual page 91

CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any component
that has this label attached. There are no serviceable parts inside these
components. If you suspect a with one of these parts, contact a service
technician.
Attention: During normal operation, each power-supply bay must contain either
a power supply or power-supply filler for proper cooling.
To install a hot-swap power supply on the 5U server model with hot-swap power
supplies, complete the following steps.
1. Read the safety information in "Safety" on page vii and "Installation
guidelines" on page 35.
2. Touch the static-protective package that contains the hot-swap power supply to
any unpainted metal surface on the server; then, remove the power supply
from the package and place it on a static-protective surface.
3. Place the power supply into the bay guides.
4. Using the handle, push the power supply toward the front of the chassis until
it locks into place.
Chapter 2. Installing optional devices
75