Parameter - Siemens SINUMERIK 840D Operator's Manual

09.01
Target group
Objective
Dependencies
Requirements
Notation of the
configuration
language
© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
This documentation is intended for the machine tool manufacturer who wants
to design his own user interface for the OP 030/MMC 100/ HMI Embedded.
Using the Development Kit and the associated function description, the
machine tool manufacturer is able to:
•
Create their own operator interface.
•
Test this operator interface on a PC.
•
Transfer the operator interface created to the target hardware and run it.
•
Create a vendor-specific master disk of the modified system for his own
service assignments.
The Development Kit used must match the version of SINUMERIK 840D/810D.
The hardware and software requirements for the use of the Development Kit
are specified in the following document:
Reference: /FBO/, EU, Development Kit
/PJE/, HMI Embedded Configuring Package
The following grammar rules apply:
"|" separates alternatives (if not explicitly expressed as a logical
-
combination),
"[" and "]" bracket optional components,
-
"..." identifies the optional repetition of parameters.
-
Parts printed in italics are user parameters.
-
Parts printed in bold characters are keywords.
-
Introduction to Configuring (PSE)
1 Introduction
PSE/1-5