Download  Print this page

Display And Modify Tool Data - Siemens SINUMERIK 840D Operator's Manual

Hide thumbs

Advertisement

Operator's Guide (BA)
3 Operation
3.11.3

Display and modify tool data

BA/3-32
1. Select the softkey "Tool data".
You can modify the geometry data in the tool data display.
Fig. 3-22
Display/modify the tool data
The display shows additional data for the tool at the loading
position.
First line:
Tool identifier (max. 29 characters)
Duplo:
Duplo number (5 characters)
TNo.:
Tool number (5 characters), internal tool number
S:
Cutting edge number (1 character). Can be
incremented with softkey "C-edg plus".
Geo:
Geometry data defining length 1, 2 (L1, L2) or
radius (R) (8 characters) can be edited (input
fields).
Wear:
Wear data
Base:
Basic data
2. Make the appropriate data modifications and then select the softkey
"OK".
The tool management basic display is then output.
You can abort the modifications by selecting the "RECALL" key.
Notes
It is not possible to unload a tool from an empty location.
The softkey is activated only if there is a tool at the
loading/unloading location.
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01

Advertisement

This manual also for:

Sinumerik 810d

Comments to this Manuals

Symbols: 0
Latest comments: