Requirement - Siemens SINUMERIK 840D Operator's Manual

Operator's Guide (BA)
1 Introduction
1.1

Requirement

Control
OEM-specific
extensions
Software update
BA/1-4
The OP 030 must be connected to a SINUMERIK 840D/810D via MPI.
The software version of the SINUMERIK 840D/810D must be approved
for the OP 030.
OEM-specific extensions, such as PLC alarms and message texts and
any dedicated user interface components, must be installed on the OP
030 for operation with a machine tool.
The software on the OP 030 can be updated with the OP 030 screen kit.
You will find a description of the software updating process in the
following document:
Reference: /FBO/, IK, Screen Kit
Attention
The software update should only be performed by suitably trained
personnel.
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01