Find Empty Location - Siemens SINUMERIK 840D Operator's Manual

09.01
3.11.4

Find empty location

© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
1. Select the softkey "Empty loc.". The Empty Location display
appears in which you can enter the magazine location type and the
tool size.
Fig. 3-23 Find empty location
You can enter the following data in this display:
−
Location type (1 character, input field)
−
Size in half-locations (left, right, top bottom: 1-character input
fields (1..7))
2. Enter the correct values and then select the softkey "OK". The
search for an empty location commences.
3. If an appropriate location has been found, the loading position is
approached. The display with the tool list appears on the screen. If
a location cannot be found, the error message "Empty location not
found" is output. You must then enter new values and start the
search again.
4. Select a tool with the cursor and select the softkey "OK". The data
are transferred to the tool management. (The tool is now loaded.)
You can cancel the empty location search by selecting the "RECALL"
key.
Operator's Guide (BA)
3 Operation
BA/3-33