Tool Offsets; Tool Management - Siemens SINUMERIK 840D Operator's Manual

Operator's Guide (BA)
3 Operation
3.10

Tool offsets

Display and
input
3.11

Tool management

Basic display
BA/3-28
•
Display of the tool offets for a tool cutting edge including the T
number, D number and the tool identification number (tool name).
•
All of the tool offset parameters can be displayed using the Page
Up/Down keys.
•
Switchover between the tool edges (up to nine edges) with the
softkeys "D+" and "D–".
•
Enter the new tool offset number.
Fig. 3-17 Tool offsets
The OP 030 tool management comprises the following functions:
1. Load tool
2. Unload tool
3. Display and modify tool data
4. Look for empty location
5. Select location in current magazine and travel to loading location
6. Select tool list for loading
7. Create new tool
For further information about tool types, location types, duplo numbers
and tool numbers, please refer to
Reference: /FBW/, Tool Management
The following basic display is output when you select the "Tool
Management" softkey:
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01