Select Location In Current Magazine; Select Tool List To Load - Siemens SINUMERIK 840D Operator's Manual

Operator's Guide (BA)
3 Operation
3.11.5

Select location in current magazine

3.11.6

Select tool list to load

BA/3-34
1. Select the softkey "Find loc.". The Magazine List display is then
output. This list shows the empty and occupied locations in the
magazine.
Fig. 3-24 Select location in current magazine
The display shows a list of all locations in the magazine.
An empty location is identified by the duplo number 0.
2. Select a location with the cursor and select the softkey "OK".
3. The tool location is moved to the loading position.
The basic display with the new tool location then appears on the
screen.
You can cancel selection of the location by means of the "RECALL" key.
1. Select the softkey "Load". The Tool List display then appears.
2. Select a tool with the cursor and then select the softkey "OK". The
data are transferred to the tool management. (The tool is now
loaded.)
A tool that is already present in the magazine (LNo. = 0) cannot be
loaded again.
If the desired tool is not defined in the list, you can create a new tool by
selecting the softkey "New tool".
Notes
•
The softkey "New tool" is activated only when an empty location is
displayed.
•
You can cancel the loading process by selecting the "RECALL" key.
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01