09.01
Software Installation
Description
Scope of supply
Hardware
requirements
OP 030
Software
components
Note on software
update program
© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
Screen Kit: Software Update and Configuration (IK)
This guide is intended to help you update part or all of the software on your
OP 030.
System Software
Development Kit
•
Standard PC with at least 80386 processor and RS-232 interface
•
Hard disk space required for
•
Operating system MS-DOS 5.0 or higher or DOS box in W9x
•
RS-232-C Cable, Order No. 6FX2002-1AA01-[length code],
see Reference:
The OP 030 software consists of the following components:
– System Configuration Files
– Alarm Texts
– User Interface Languages
– Application Program
– System software
The software update program is an individual part of the system software (on
the OP 030 hardware) which exchanges the software components listed
above.
1 disk (SYSTEM DISK) or
3 disks (DEVELOPMENT KIT)
System software approx. 5.5MB
Development Kit additional 20MB
/Z/, Catalog NC Z, Accessories
(settings for communication addresses
of the partner)
(PLC user alarms)
(two languages you defined for the operator
interface)
(proj.dat, the operator interface configured)
(complete basic system of the OP 030)
1 Software Installation
1
IK/1-3