Program Mode Entry; Parameter Value Alteration - Siemens sitrans LU10 Instruction Manual

Program Mode Entry

Upon initial power application, the SITRANS LU10 displays "OFF". To enter the PROGRAM
mode:
1. Ensure the enclosure lid is secured by the six captivated screws.
2. Place the infrared programmer in the enclosure lid recess (no wiring or
fastening required).
3. Press
When the PROGRAM mode is entered after RUN mode operation, all operating data is
retained in memory. Relay status and mA output values are held at last known values
(unless affected by a parameter alteration or
entered. The RUN mode is automatically re-entered if the SITRANS LU10 is left
unattended in the PROGRAM mode for an extended period.

Parameter Value Alteration

In the PROGRAM mode:
1. Press
a) key in the desired Parameter Number, (direct access) or
b) press
(As preset, Quick Start Parameters and any previously altered parameter may be scroll
accessed.)
2. Press
a) key in the desired Point Number, (direct access) or
b) press
To alter the Parameter Value for all Point Numbers at once, direct access To alter the Parameter Value for all Point Numbers at once, direct access To alter the Parameter Value for all Point Numbers at once, direct access To alter the Parameter Value for all Point Numbers at once, direct access
3. With the desired Parameter Number and Point Number displayed, key in the desired
Parameter Value and press
If Parameter Value alteration is not permitted, access the Lock parameter (P000) If Parameter Value alteration is not permitted, access the Lock parameter (P000)
If Parameter Value alteration is not permitted, access the Lock parameter (P000) If Parameter Value alteration is not permitted, access the Lock parameter (P000)
and enter the security code (See Programming Security). and enter the security code (See Programming Security).
and enter the security code (See Programming Security). and enter the security code (See Programming Security).
7ML19985AN02
.
as required to underline the Parameter Number display field and
or as required (scroll access).
as required to underline the Point Number display field and
or as required, (scroll access).
Point Number 00. Point Number 00.
Point Number 00. Point Number 00.
SITRANS LU10 – INSTRUCTION MANUAL
is pressed) until the RUN mode is re-
Page 17