Procedure - Siemens SINUMERIK 840D Operator's Manual

09.01
1.3

Procedure

© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
The OP 030 is configurable to enable optimum customization of the
user interface according to the particular requirements of the machine.
The OP 030 is supplied with standard operating functions (in binary
format). The sources for these standard operating functions are
contained in the Configuring Kit (OP 030 Development Kit).
You can configure the system in one of two ways:
•
Extending the standard user area
You can use the full range of functions of the standard
configuration.
You can use all update versions of the standard configuration
immediately.
The standard configuration contains a softkey for switching to a
prepared initial window for application configuring. You can expand
the system from this point.
•
Substitution of the standard user area
You can customize the entire user interface. Templates for specific
applications can be taken over from the standard configuration.
Development Kit (EU)
1 Introduction
EU/1-5