Siemens SINUMERIK 840D Operator's Manual page 50

Operator's Guide (BA)
3 Operation
Start/Stop
Specify target
directory
BA/3-42
Note
Caution! Switching off the power supply results in a loss of the
parameter assignments entered.
Press the "Start" softkey to display the "Target directory" window.
Three different procedures are possible.
1. Path/workpiece from archive file
The directory paths for the files read in are also stored.
2. Nothing selected
All files are copied to the directory previously selected with the
cursor irrespective of the directory paths.
3. Copy to clipboard
All files are copied to the clipboard irrespective of the directory
paths.
Use the cursor and the Input key to make the selection required and
press the "OK" softkey to confirm.
Fig. 3-39 Specify target directory
Then the "Transmission in progress" screen is displayed.
Fig. 3-40 Transmission in progress
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01