Tool Parameter Identifiers - Siemens SINUMERIK 840D sl Commissioning Manual

13.3.2

Tool parameter identifiers

For the tool parameters, the following identifiers are used in the configuration file:
Content_identifier
Empty
ToolNo
AdaptNo
DuploNo
NumCuttEdges
ToolIdent
ToolIdentRO
ToolInfo
ToolInMag
ToolInPlace
ToolInMagInPlace
ToolMonTCW
ToolMonTC
ToolPlaceSpec
ToolSearch
ToolMyMag
ToolMyPlace
ToolSizeLeft
ToolSizeRight
ToolSizeUpper
ToolSizeDown
ToolOverSize
ToolStateActiv
ToolStateEnabled
ToolStateLocked
ToolStateLockedRO
ToolStateMeasured
ToolStatePrewarn
ToolStatePrewarnRO
ToolStateInChange
ToolStateFixed
ToolStateUsed
ToolStateMarkedToUnload
ToolStateMarkedToLoad
ToolStatePermanent
ToolAlarmIsExtended
ToolAlarmLimit
HMI sl (IM9)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
Parameter or property
Empty field
Number of active tool
Adapter number assignment
Duplo number
Number of cutting edges of tool
Tool name
Tool name, read only access
Tool information
Magazine in which the tool is located
Magazine location containing the tool
Magazine number/Magazine location
Type of tool monitoring, tool life, workpiece count and wear. If wear
monitoring has not been enabled via the machine data, this
parameter is handled like ToolMonTC.
Type of tool monitoring, tool life and workpiece count
Location type
Tool search type for replacement tools
Owner magazine of the tool
Owner magazine of the tool
Tool size left in half locations
Tool size right in half locations
Tool size upper in half locations
Tool size lower in half locations
Tool size as fixed setting - two half locations left, two half locations
right, one half location top, one half location bottom
Tool status - tool active
Tool status - tool released
Tool status - tool locked
Tool status - tool locked, only read access
Tool status - tool measured
Tool status - tool has reached prewarning limit
Tool status - tool has reached prewarning limit, only read access
Tool status - tool is being changed
Tool status - tool fixed place coded
Tool status - tool was in use
Tool status - tool is marked to unload
Tool status - tool is marked to load
Tool status - tool is permanent
PLC tool status - function "extended alarm" active
PLC tool status - alarm limit reached
Configuring tool management
13.3 Configure the tool lists
87