Installing The Application Configuration - Siemens SINUMERIK 840D Operator's Manual

Development Kit (EU)
5 Installation and Delivery of the Application Configuration
5.1

Installing the application configuration

Requirements
Installations
process
EU/5-42
•
An OP 030 environment is installed on your PC (OP030set.bat).
•
PC and OP 030 hardware are connected by a V24 cable:
(modem eliminator, order no. 6FX2002-1AA01-[country code],
see Reference:
•
Your application configuration is located in L:\bin\proj.dat
•
If you want to use other languages instead of German/English
on the OP 030, the appropriate directories (e, f, i) under proj\text\al
and proj\text\pj must be run through during text conversion
(see 6.2).
The installation process transfers your configuration settings, texts,
your configured user interface and, if necessary, the OP 030 system
software (update) from your PC to your OP 030.
You can select the following components for transfer:
- System Configuration Files
- Alarm Texts
- User Interface Languages
- Application Program
- System Software
The selection of a component means that the components specified
before it are also transferred to your OP 030. (This is necessary for
reasons of integrity.)
SINUMERIK 840D/810D Configuring the Operator Interface OP 030 (FBO) – 09.01 Edition
/Z/, Catalog NC Z, Accessories).
(Settings for device parameters
and communication addresses)
(PLC alarms)
(Two languages of your choice
for the user interface)
(proj.dat, the configured user
interface)
(L:\flashbin\*.bin, the complete
base system of the OP 030)
© Siemens AG, 2001. All Rights Reserved
09.01