Siemens SINUMERIK 840D Operator's Manual page 121

09.01
Using the OP 030
Development Kit
Procedure
Entries obligatory
for INSTALL
© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
Screen Kit: Software Update and Configuration (IK)
The following applies if you intend to perform the software update from an
installed Development Kit:
•
The alarm texts are not converted by mkalarm but by the makefiles
contained in the development kit.
•
The user interface texts are available as *.txt files and are also converted
by the makefiles.
•
The OP 030 application program 'proj.dat' which was generated under
L:\bin is transferred to the OP 030 hardware.
Connect the OP 030 to your PC with the RS-232-C cable mentioned above to
COM1 or COM2.
On the OP 030:
•
Switch on the power supply to the OP 030 or activate the Power-ON-
Reset. The OP 030 runs up and for 5 seconds the menu for further
operator input appears.
•
During the 5 seconds, you can change to update mode by entering the
digit 6 on the OP 030.
•
Select a baud rate (57.6 kBaud recommended).
On your PC:
•
Change to the directory <Ziellaufwerk>:\OP 030
(when the DEVELOPMENT KIT is installed, this is substituted by L:\).
•
Start the update by entering (select 1 from setup)
"INSTALL".
•
Select software components to be transmitted (see above).
•
For text files: select foreground and background language.
•
For transmission of system software:
Specify whether the OP 030 hardware contains the current software
version of the software update program.
•
Select configuration file(s) to be edited if required.
•
Select serial interface and baud rate for transmission.
1 Software Installation
IK/1-7