Information; Operator Panel - Siemens SINUMERIK 840D Operator's Manual

Hide thumbs Also See for SINUMERIK 840D:
Table of Contents

Advertisement

09.01
1.5

Information

© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
Screen Kit: Software Update and Configuration (IK)
MM_V24_ PRINTER _DATABITS
MM_V24_ PRINTER _PARITY
MM_V24_ PRINTER _STOPBIT
MM_V24_PG_PC_XON
MM_V24_PG_PC_XOFF
MM_V24_ PG_PC _EOF
MM_V24_ PG_PC _CONTROLS
MM_V24_ PG_PC _RTS
MM_V24_ PG_PC _BAUD
MM_V24_ PG_PC _DATABITS
MM_V24_ PG_PC _PARITY
MM_V24_ PG_PC _STOPBIT
The following parameters are used as a default setting for tool management:
MM_TM_SINTDI
MM_TM_NUM_MAG
MM_TM_UNLOAD_AND_DELETE
MM_TM_LOAD_TOOL_NEW
MM_TM_TOOL_STATE_DEF_VAL
MM_TM_ACT_SEARCH_AND_POS
MM_TM-LOAD-LOC1
MM_TM-LOAD-LOC2
MM_TM-LOAD-LOC3
MM_TM-LOAD-LOC4
MM_TM-LOAD-LOC4
MM_TM-LOAD-LOC5
MM_TM_LOAD_PLACE
For application and range of values of these parameters, please refer to
Reference:
/IAD/,
Read the latest information for any software version in the attached file
SIEMENSD.TXT (German) or SIEMENSE.TXT (English).
Installation and Start-Up Guide, Section on Machine
Data for Operator Panel
1 Software Installation
IK/1-11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 810d

Table of Contents