Siemens SINUMERIK 840D Operator's Manual page 37

09.01
© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
Fig. 3-18 Status: A tool can be loaded
Fig. 3-19 Status: A tool can be unloaded
The basic display for tool management functions specifies the data of
the tool in the loading/unloading location. The display cannot be edited.
First line: Tool identifier (max. 29 characters)
Duplo: Duplo number (5 characters)
MNo.: Magazine number (4 characters)
LNo.: Location number in magazine (3 characters)
LT: Location type (1 character)
LStatus: Location status (8 characters):
−
G – disabled
−
F – free
−
Z – reserved
−
B – reserved
TStatus: Tool status (8 characters)
−
A – active
−
F – enabled
−
G – disabled
−
M – measured
−
V – prewarning limit
−
W – changing
−
P – coded for fixed location
−
E – in use
Operator's Guide (BA)
3 Operation
BA/3-29