09.01
1.1
SETUP
Procedure using a
disk
Procedure for the
Internet
© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
Screen Kit: Software Update and Configuration (IK)
The Setup procedure for the system software or Development Kit is identical.
Depending on how the software has been purchased, the procedure either
requires a disk or operates via the Internet.
•
Insert DISK 1 in the disk drive of your PC.
•
Start the setup by entering the command "SETUP_OP".
•
The update environment requires approximately 20 seconds to be
created.
•
Create a catalog of your choice, e.g. OP_SETUP on the hard disk of your
PC.
•
Copy or extract (if purchased directly from Siemens) the files in this
catalog.
•
Change the source (FROM) and also, if required, the target (TO), in the
env_data.bat file using a standard editor, e.g.:
_FROM_HD=c:
_FROM_DIR=OPSETUP
_TO_HD=c:
_TO_DIR=op030
In this case, the source files in the c:\OP_SETUP catalog are copied to
c:\OP030.
•
Start the setup by entering the command "SETUP_OP".
•
Follow the SETUP dialog to select your update directory and the packages
to be installed.
•
The update environment requires approximately 20 seconds to be
created.
1 Software Installation
from the drive
from the catalog
to the drive
to the catalog
IK/1-5