Introduction to Configuring (PSE)
5 Steps for Configuring the OP 030
Transfer application
to hardware
Create disks
PSE/5-30
In the DOS box, select the L:\ project drive.
1. Call "INSTALL.BAT"
2. You can select the following components for transfer:
•
System Configuration Files
•
Alarm Texts
•
User Interface Language
•
Application Program
•
System Software
3. Start transfer
Note
The transfer procedure is considerably quicker under MS-DOS than it is under
Windows.
Two installation disks are created. They contain:
•
OP 030 basic system
•
Configuration
•
Binary language files for 5 languages
•
Alarm text source files in 5 languages
•
System configuration files
•
Setup/Install routines
•
MKALARM.BAT for the conversion of alarm texts
1. In the DOS box, select the L:\ directory
2. Call "MAKEDISK.BAT"
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01
▄