09.01
1.2
Use
Target group
Objective
1.3
Screen Brightness
Runup
Brightness
setting
© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
This documentation is intended for end users of the SINUMERIK
840D/810D control with the OP 030 operator panel on a machine tool.
This Operator's Guide is intended to provide the end user with a brief
overview of the basic operating functions.
This Operator's Guide also contains a description of the operating
sequences defined by SIEMENS as standard user areas.
After Power ON or Reset the OP 030 runs up, displays the version and
tries to make contact with the NC for approx. 90 seconds. If this is not
successful, it must be acknowledged before a new attempt can be
made.
During the runup period the "+" and "-" keys can be used to set the
brightness of the screen display. "+" increases the brightness.
Unfortunately, this setting is not accepted in the executable HMI
program.
Operator's Guide (BA)
1 Introduction
▄
BA/1-5