Second Bias Transfer Roll Unit - Xerox WorkCentre 7132 User Manual

Second Bias Transfer Roll Unit

Removing the Old Second Bias Transfer Roll Unit
Xerox WorkCentre 7132 User Guide
Downloaded From ManualsPrinter.com Manuals
The Second Bias Transfer Roll unit lasts approximately 150,000 copies and prints. The
machine will display a warning message approximately 1,500 copies and prints before
the unit reaches the end of its life. Another message will be displayed at this point when
the unit needs to be replaced.
CAUTION: The left-hand cover should not be opened while the machine is operating.
If the left-hand cover is opened, the machine automatically stops. Push firmly to close
the cover, as it may become difficult to close. Follow the messages on the screen, if
present, to remove any paper jammed in the machine.
1.
Select [Second Bias Transfer Roll] on the [Supplies] screen or the [Consumables
Status] screen.
2.
Pull the side cover open.
3.
Loosen the two screws securing
the Second Bias Transfer Roll
unit by rotating them
anticlockwise.
4.
Hold the loosened screws to
remove the Second Bias
Transfer Roll unit from the
machine.
NOTE: Be careful when handling the
Second Bias Transfer Roll to avoid
contact with any residue toner left on
the unit.
NOTE: Make sure not to hold any
other parts other than screws to remove, in order to avoid deforming the metal part of
the Second Bias Transfer Roll unit to prevent potential paper jams.
SMart Kit (Customer Replaceable Units)
365